II.D Warming and cooling devices
II.E Infusion and rapid infusion devices
III.E.1 Fluid/blood component replacement
Warming devices and rapid infusers
Why your patient loses the most heat in the first hour, what actually puts it back, and how to move warm blood fast.
By the end you can
- Name the three phases of intraoperative heat loss and what drives each one
- Pick a warming method that matches the phase, the exposure and the fluid rate
- Set up a fluid warmer or rapid infuser safely and say what limits its flow
Your case
OR 6 · Emergency laparotomy · 60 min after induction
Mrs. K, 58, 70 kg, bleeding from a ruptured splenic artery aneurysm. Straight to the room, no prewarming. The surgeons asked for the room at 19 °C.
Two liters of crystalloid and 2 units of red cells are in. A forced-air blanket is on her legs. The abdomen is open.
Esophageal 35.2 °C
HR 118
MAP 62
pH 7.28
Hold that thought
- She was 36.8 °C at induction and she was covered. Where did the heat actually go?
- The fluid warmer is running. At this rate, is it doing anything?
- What is 35.2 °C costing her while the surgeon is still working?
You will answer these at the end of the lesson.
Members only
The rest of this lesson is for members
Membership opens all 98 lessons, every cheat sheet and memory card, the full question bank, and simulation exams.
Not ready to join? Free account: take the 50-question diagnostic, see your weakest domain, and get a study plan built around your exam date. No card.
Start free
Inside this lesson
- Start
- The case
- Broken thermostat
- Four routes out
- Three phases
- What it costs
- Warming methods
- Fluid warmers
- Rapid infusers
- Heat loss timeline
- Cooling on purpose
- Mnemonic
- Board traps
- Cheat card
- 5-question quiz
- Wrap-up